Questions & Answers for: Chevrolet Silverado 1500 replace 4 wd switch

...4/wd componants and parts on a 2000 chevy silverado z71 for free service 4/wd is on . lights on selector switch are off most of time. when they do come on they just blink off and on and the truck ...

Ad

Question about 2001 Silverado 1500

1 Answer

4 wd not engaging on checy 1500 PU. IN the 4 wd not engaging on checy 1500 PU. IN the morning the unit engage in hi and low and the light indicator come on. IN the afternoon the light was not coming ...

Ad

...WITH DOOR OPEN WHEN YOU PUSH 4 WHEEL SWITCH YOU SHOULD HEAR MOTOR INGAGE 4 WHEEL DRIVE. IF YOU HEAR MOTOR BUT STILL NO 4 WHEEL DRIVE THE GEAR ON MOTOR COULD BE DAMAGED. REPLACE TRANSFER CASE

where to get a replacement 4 wd push button switch The four wheel drive range selector switch is readily available at any GM dealership. Quite easy to install as well.

Question about 2001 Silverado 1500

1 Answer

...4 wd. They are bad about sticking. Sometimes you can reset them by disconnecting the negative battery post for a few minutes. If that doesn't work carry it to the dealer. They will find the problem ...

Question about 2005 Silverado 1500 2WD

1 Answer

...wrong. Do i take the motor apart or can i turn the gear on the side of the transfer case without hurting anythig? i think you mean 05 1500 4 wd anyways yes you can turn it and no it wont hurt ...

Question about 2005 Silverado 1500 2WD

1 Answer

...4 WD and it is good. There are no unusual noises there is a vaccum actuator on the frontend, you will see it on the punkin, with a plug on it, have someone turn your 4x4 switch and see if its moving ...

Question about 2005 Silverado 1500 2WD

1 Answer

...4 wd and service engine soon. stuck in 4 wd high. actually i would say it is the vaccum actuator on the frontend thats not applying, i dont think its a transfer case issue.. if you look on the punkin ...

Question about 2005 Silverado 1500 2WD

2 Answers

...4 wd high. dealer did diagnostic test, scan for fault code co327 set, test 8v ref circuit,test groung circuit, test channel circuits to module, all good, connector clean.said it was transfer case ...

...4 high. Push for 2 wd. the light in dash will go from 4high to 2 high blink a few times and goes back to 4 high. both electric motors one on the transfer case and front drive sounds as if they are ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...