...on dash, 6 1/2" Mids in the driver and passenger doors, 6X9"'s in the rear seat, and added (2) 10" Rockford Punch Phase 2 subs in the cargo area with a Rockford 3000 W. amp to power. Sounds
...replace the entire window assembly (except the glass). It was pretty easy. You take the door panels off, unplug the motor, support the glass with a prop, take out about 6 screws, and the whole track ...
...6 point socket is preferred. This will remove the battery cables without rounding them Be sure not to allow the cables to touch while one is still connected to the battery. If you want to save your ...
...6 months later the battery continues to die within a few hours and we cannot find the problem. We tested and replaced the battery, tested the alternator and relays. Any suggestions. take a test bulb ...
...6 to 8 inches apart all along the panel itself. They will release with pressure. Get as close to each pin as you can before prying between the door and the panel, blade tip down against the metal of ...
Question about 2004 Envoy
6 misfire changed plugs coil and injector still misses sometimes i heard a bad valve seat will do it and its common is this true Yes a valve problem could cause the loss in power on one cylinder. That
Question about 2003 Yukon XL
6. Passenger side blend door actuator or relay may be burned out. 7. Do all the gauges work on your dash cluster? If not you may be hearing sounds relating to that. If there are non-functioning gauges
replace the existing key. Before beginning the relearn, make sure there is a fully charged battery in the vehicle, and both the BCM and PCM are properly powered up and in communication with each other
Question about 2002 Envoy
...6 Disconnect the memory seat switch connector from the driver door module. Using a DMM, test the resistance through the memory switch from the voltage supply circuit terminal to the memory 1 switch ...
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions