crank sensor. (I'm not sure if nissan works the same way). Crank sensor suppose to send a signal to fuel injector reporting the RPM. if it's cracked, it would report a lower voltage( less than 800 RPM
car will not start or stay running has good compression have replaced crank sensor cam sensor fuel pump ignition coil spark plugs and wire and pcm did you replace the ignition switch?
...sensor, crank sensor, distributor and distributor cap and ADP relay. I've also had the fuel lines cleaned. Despite the check engine light coming on, there are no error codes registering. Any ideas? I ...
crank shaft sensor and wire harness so I did. The car will not start. It will turn and sound like it wants to start but does not. What else could be wrong? Also after the sonsor was replaced the check
...box..no change..Sometimes it will run just fine other times it cuts off 5 times in 20 miles..whats my next move..this car is a dud just change the crank sensor,You have an inntermitent fault with
...replace almost all gaskets and when I put it back together i got fuel and juice but NO SPARK!!!!!!!! i put in a newer PCM from a 98 but same everything else and i had to slice all the wires and match ...
...may need to have the timing belt replaced but if you know that the belt is ok then you should try replacing the crank sensor. this will give you atleast a place to start. Computer failure is
crank sensor and ignition module failure try replacing the crank sensor first the the ignition module if you need to replace the module do not use remanufactured buy new to save headache in the future
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions