#160;over thus the clicking. Try charging the battery or jumping, if you still get a clicking it would be the starter solenoid. Considering the year you may just want to replace the whole starter
...replace the entire unit with a new one. Remove the two attaching screws, then slide the solenoid out of the starter motor housing flange. Fig. 5: Before removing the starter motor solenoid, matchmark ...
...tracker and it did nothing. light and everything came on though. i check battery and it was fine. i replaced the pos and neg battary cables. the ground only goes to started/bell housing. is there ...
starter and cleaned all the wire to the battery. this worked for a while . then when i turn the key with the spade connector on the solenoid off everything come on , then i reconnect it and everything
Question about 1992 Tracker
...starter solenoid goes thru the key switch then thru a clutch switch before getting to the starter. You would need to check the key switch and clutch switch, also check the ground and battery ...
starter solenoid replacement Generally the solenoid is replaced with the starter.
Question about 1994 Tracker
...replace a starter, and 1hr second time. depends on, if bolts are seized, or bad, or wont budge. if you live in the SALT belt, it can be a real hard job. q2: dead head, the radio (tape, wow tape, is ...
...solenoid on the starter that takes over the job of the high amp. Draw of the starter. You won't be able to change the solenoid so the stater assembly will need to be replaced. This is my best advice ...
Question about 1994 Tracker
starter on the batt. terminal, the one going to the battery. Check for power at the start wire terminal, the little one, this is done while someone turns the key to start position. Check that power is
Usually answered in minutes!
350 Questions
228 Questions
207 Questions
191 Questions
187 Questions