Questions & Answers for: Pontiac Montana replace starter solenoid

...replace their starter on their Pontiac Montana mini-van. After replacing the old starter with a brand new after market Hitachi starter and checking relays and replacing the battery- the vehicle still ...

...replace the starter solenoid on my 2000 Pontiac Montana. Anyone know how this is done? It does not look easy to get at!! jman On your van the solenoid is attached to the starter. If you can get a ...

...Solenoid on the starter needs to be replaced, serviced, or the wiring leading to it., and from the Solenoid to the starter is a small copper band that is attached with a 7 or 8mm nut. Any corrosion ...

...battery. Hello! There are two solenoids or coils in the starter motor for your vehicle...One to pull and one to hold...The hold coil or solenoid is open...Replace the starter motor... ...

...starter solenoid due to burned main battery contacts, very common on newer gear reduction starters. The wires you shake may have a broken charge wire from alternator to the battery or a fusible link ...

...the website he bought it from. try the link faulty starter solenoid possibility, if it doesnt start give the starter a tap with a wrench if it starts after that change solenoid or replace

...checked the battery and fuses and still i turn the key and the motor doesnt crank over There is an ignition/starter switch on the left side of the steering column that activates the starter

replace starter. Where is it located? The starter is located on the lower side of the motor. Disconnect negative battery cable. Raise and support vehicle. Remove flywheel cover (s). Disconnect starter

replace the starter and i checked the solenoid wiring there is no power supply? Check battery and connection. Hi Randy There is No Power Supply? That suggests No Battery..... I think you mean no power

...starter motor solenoid S terminal nut to 3 [n-m] (27 lb in). Install the starter motor BAT terminal electrical leads and nut. Tighten: Tighten the starter motor solenoid BAT terminal nut to 10 [n-m] ...