technics amp model saex120. information on digital front reads "system overload" and will not produce sound. The audio amplifier IC are damaged you need to replace them.
technics SA-AX720 AMP WHEN I TURN IT ON IT JUST SATS OVERLOAD IF I PRESS ANYTHING IT SAYS SWITCH OFF POWER The audio amplifier IC of your device are damaged you need to replace it.
...amp IC, reference # Q5001, which is an STK402-950 (Onkyo Pt. # 222123). Typically fails as a result of excessive volume levels or as a result of problems with the speakers or their wires. If you're ...
Technics SU-G88. When volume is wide open get small amnount of sound, as sugested I have already replaced the op ic IC602 and this did not help. Is it possible that both audio power modules bolted to ...
Technics SU-G95 Amplifier and I don't have any sound coming out of the left side, on both the A and B speakers. Do you think it's the balance control or might it be something more complicated? Usually
...IC for Technics amps. Regards B.Saravanakumar You need to post the reference number of the IC into Google. My reference book shows that Technics is connected to Panasonic, but it could be out of
...technics SU-G50,how do I know if the main power module is blown? The system lights up but doesnt produce any sound and the relay in the power amp section is shot. Also where can I get a replacement ...
Question about Technics cassette deck rs-br465
...IC-901) is not working. It is impossible to find a new replacement for this microcontroller, the deck is too old. I was planning to buy an old technics tape deck and use it as replacement bank of ...
Question about Technics cassette deck rs-br465
...IC's and regulators that are on the heatsink. Most of the technics receivers had an access panel that can be removed from the bottom of the unit, and then you can visually inspect for any bad ...
Question about Technics cassette deck rs-br465
Technics amplifier SU-X320. Problem is it powers up up there is no sound. Checked all basic fault finding, suspect it is the volume IC. "Volume IC" do you mean an IC that is a pre-amp and controls the
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions