Questions & Answers for: replacing turn signal socket 2001

...turn signal randomly works and/or (2) emergency flashers randomly work. The good news is that one switch will fix all four turn signals plus your emergency flashers (my cost at dealer was $119.99 - ...

...turn signal speed or is it controlled strictly by the bulb itself? Gregg - I had the same problem. It was a defective lamp socket on the driver's left side, Volvo Part Number 8662985. Costs me $11.24 ...

...TURN SWITCH SOMETIMES THEY WORK SOMETIMES THEY DONT The socket assemblies and connectors at the back go bad and melt on these vans. Take the tailight assembly out and inspect the harness and ...

...turn signal housing -- mine cracked at the top, let water in, and blew out bulbs and corroded the sockets. replacing the socket helped, but they'd fill with water until i replaced them. unfortunately ...

...turn signal keeps burning out and the socket that it fits into looks kinds melted #04083: Product Safety - Rear Stop/Turn Signal Lamps Inoperative This is a safety bulletin GM had out in 2003, it ...

turn signal and brake light dont work. Check the bulbs if the bulbs are good suspect the panel that the bulbs go into. Which are also called the sockets you may have to replace the sockets this is not

...turn signal bulb ? Thx.... Side-mounted turn signals, removing: 1. Press side turn signal lens against retaining tab in direction of arrow and carefully remove from fender opening. 2. Carefully pull ...

...turn signals is. No high beams makes me think someone may have had the steering column out and the high beam switch is out of adjustment or the rod that controls that is out of its socket. I do not ...

0L-5.7L/how-to-test-the-turn-signal-switch-1) - if none of these reveal the issue, I believe you're left with the body control module (BCM) - this will require replacement and reprogramming. Good luck

TURN SIGNAL BULB ON A 2004 VENTURE VAN? I NEED TO PULL OUT THE RIGHT TURN SIGNAL ASSEMBLY ,SO I CAN REPLACE BULB AND RE-SEAL HOUSING. I believe there should be an access panel on the inside of the van