...equinox? Hi to reset the oil life monitor turn the key on engine off push the gas pedal to the floor 3 TIMES WITH IN 5 SECONDS the light will flash then go out Hear it is the full procedure how to ...
...You can find the oil light reset procedure here ...
...RESET OIL LIFE MONITORS ON 2008 CHEVY EQUINOX Equinox 2005-onwards Turn ignition to the "ON" position. Slowly depress accelerator pedal 3 times within 5 seconds. "CHANGE OIL SOON" lamp will flash. ...
2008 equinox is throwing the p0118 code. The car says the engine is hot and turn a/c off. Although the temp gauge is all the way down at 0 temp. This problem is intermittent and will sometimes" fix" ...
...disconnected the ground cable from the battery, wait ten minutes and hook it back up. This should reset
Question about 2008 Equinox
...Equinox it dose not want to start what can I do for that problem I have only had the car less than a week went out to start it so i could leave and it will not start. I have tried to reset the codes ...
reset engine light Just unhook the battery cable for a couple of minutes. After hooking it back up the engine code should be gone. If you have something wrong with the car it will eventually come back
...reset control module on a 2008 equinox easiest way, remove the negative battery cable off the battery terminal and leave it unhooked, go eat lunch. come back and hook it back up. should reset ...
Question about 2008 Equinox
...equinox,stabilitrac and traction control lights come what is the simple fix? have not yet tried anything run the fault codes to determine the exact sensor that is faulty I had the same " stabilitrack ...
need to reset stabilitrak light Unhook the battery for 5 mins to clear all codes. If it come back on there is a hard code and it needs to be checked.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions