right side ok left temp coming out 18 to 20 not as fluffy as middle/right side have regularly changed blades any help is appreciated-machine is located in concession trailer and distributors refuse to
...right side will stop workng just as the porduct gets up to consistancy. Do you think it is a weak or bad motor. The motor just stops and then when the product starts to warm up I can get it to work ...
...right side was being tripped.) Did you check the wiring ? This motor is reversible and you may not have the wires under the connection plate. A model number would be very helpful as I am looking at ...
Question about Frozen Yogurt C713 Soft Serve Ice Cream Machine
...the left side hopper (standing in front of the machine) is icing up and the right side hopper is not cold enough, the problem is low refrigerant in that system. It takes R134A. Soft Serve Parts ...
Question about Frozen Yogurt C713 Soft Serve Ice Cream Machine
...Right side is cooling and working ok, hopper temperature about 33-35 F, but left one is not stopping in auto mode until I turn s.s. viscosity refulator counterclockwise a little bit, product ...
Question about Frozen Yogurt C713 Soft Serve Ice Cream Machine
Hello, I have a taylor Model 161 Soft Serve Freezer. My drive beater on the right side is stuck and I can't Remove it. I tried WD 40 with no luck?? You need to try heating it with a propane torch.
Question about Frozen Yogurt C713 Soft Serve Ice Cream Machine
...right hand side, there is a large ice cream cone. Press the center of that ice cream cone. It'll ask you to enter a code. Using your up and down arrows, enter the code 5231 pressing the SEL button ...
Question about Frozen Yogurt C713 Soft Serve Ice Cream Machine
...right side hopper and that will determine the temp of both sides. If there is a large temperature difference between the two sides then it may be that you are low on refrigerant. You may have enough ...
Question about 794-27 Soft Serve Twin Twist Water Cooled Frozen Ice Cream Machine
...right side isn't getting cold. I checked standing pressure on both sides and seems to be the same. What would cause this? The dryer or something else? Is there a valve that could be bad? I worked on ...
Usually answered in minutes!
0 Questions