are 1994 s10 upper and lower ball joints pressed in the upper ball joints are rivited or bolted if yhey have been replaced before the lower ball joints on a 2WD are pressed in the lower ball joints on
...you have a pop rivet gun?). Charlie Yes they are rivited. You need to remove them, and replace the rivits with new ones. No one said this was easy. Drill out the head of the rivit with a larger
how do you remove the rivit to replace the roller I'm needing to replace the window regulator roller and rivit on a 1989 gmc s-15. How do I go about doing this Oh, isn't that fun? They say that you ...
...check the ball joints they go on these year blazers 95 -99 there rivited in on the uppers and the rivits go and the wheel almost falls off so be careful with ...
interior door handle is rivited n to the door how do i remove rivits so i can install the new drivers side door handle Drill out rivets. The replacement handle will either have nuts & bolts or ...
I got the door panel off. My problem is that I can't get the pop rivets off. Use a small punch to punch the center pin out of the rivit,then use a drill on the rivit head,the pin is hard,once it's ...
PHILLIPS HEAD ON IT, TO REMOVE DOOR PANEL.YOU WILL NEED A CENTER PUNCH TO POP OUT THE CENTER OF THE RIVITS THAT HOLD THE MOTOR AND THE REGULATOR TO THE DOOR.THEN YOU WILL NEED TO DRILL OUT ALL RIVITS
Question about 2004 S-10
need a solution for fixing an electric operator for the power window on my S 10 chev. the fastners holding the operator to the door look like a pop rivit and are pulling thru the holes in the do, how ...
removing step cover MY BOSS HAD THE SAME PROBLEM. YOU HAVE TO DRILL OUT ALL THE RIVITS, FIX WHAT YOU NEED TO AND THEN REPLACE THE RIVITS!! Contact your local service center directly or online here:
Question about ProTeam Alpine CM DT100 HipStyle Vacuum Cleaner Now known as Tailvac
do I replace the receptacle? there are rivets that need to come out. How do you remove them? If the rivits need to come out You will need a drill and bit small enough but not too big and drill it out,
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions