torque specs WHAT IS THE TORQUE SPECS FOR CONNECTING ROD CAPS ON A 2004 2.3L FOCUS MOTOR? 2002 2.0L Duratech. Don't have 2004 2.3L NOTE: Use new connecting rod bearing cap bolts. NOTE: Do not fully ...
Question about 2000 Rodeo
...rod bearings torque specs. 1. Check the connecting rod alignment If either the bend or the twist exceeds the specified limit,the connecting rod must be replaced. Bend per 100 mm (3.937 inch) Limit: ...
...ROD BEARINGS IS 43 FT LBS. THE 2.6 ENGINE MAIN BEARING TORQUE IS 72 FT LBS ROD BEARINGS IS 43 FT LBS.THE 3.1 ENGINE MAIN BEARING TORQUE IS 72 FT LBS. ROD BEARINGS IS 39 FT LBS.THE 3.2 ENGINE MAIN ...
...rod bearings and main bearings for 3.8L GM engine 1979 to 1981 FOR 1979 ROD BEARINGS TORQUE IS 40 FT LBS MAIN BEARINGS 100 FT LBS. FOR 1981 MODELS. ROD BEARINGS TORQUE IS 40 FT LBS. AND MAIN BEARINGS ...
Question about 1994 Trooper
rod bearings and the clearance between the bearing and crankshaft i am rebuilding both in line 6 engines. that would be the 2.8L 170 cid and the 3.3L 200 cid. i would like to know the torque in ft-lbs
rod bearings, and crank wont turn. ??? checked #'s on rods and caps, and they are fine. what else could it be? check that you kept the caps and rods as units as any one cap will not fit any other rod.
...rod bearings If you have to ask it's way over your head. Rod bearings are about as deep into an engine as it gets. Best bet is to pull the engine and take it to a machine shop. I have a 2006 Saturn ...
Question about 2004 ION
...set of rod bearings, one oil pan gasket, and all eight rod nuts. How do I take out the old stuff and put in the new stuff? http://www.paragon-products.com/kb_results.asp?ID=63 Full list on what to ...
...the rod bearing if a toyota celica con rod bearing ? poor oil pressure worn bearings over revving if a con rod breaks when engine is running rod through the block or piston pushes up through the ...
Question about 2004 ION
...rod has bearings at both ends for a snug, smooth fit to the crankshaft. Over time, or due to low oil levels or heat, your connecting rod bearings may wear and allow for play on the crankshaft. This ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions