Questions & Answers for: room fan turning itself

...room is to warm (according to manual) that is false also. Any suggestions. i tried cleanig the fan in back and using a house fan to keep air circulating,...no luck...please help It is possible that ...

...fan blowing. What part do I need to fix it? Thanks very much. before you go to fix it, what is the setting it is at? What is the tempurature of the room it is in? If the setting has been satified the ...

...room fan worked for this Hunter bedroom fan so when adjusting one fan or the other would adjust both fans) Recently though I went to turn on the bedroom fan and the lights keep surging on and off and ...

...unfortunately it is now well out o warranty but have the same fan in another room purchased same year 2003 which is moving along fine. Cannot find instruction book for either one. Please help. ...

...fan continuously despite the fact that the room has reached the set humidity level. This design feature is intended to keep the air moving which helps mildew problems in both the room and on the ...

room temperature is 70, the fan will reverse to bring the warmer air (which is always closer to the ceiling) down and warm the room until the set temperature is reached, then the fan turns itself off.

...room/switch before you do anything. The installation itself is simple - just wire + to + and ground it. Did you notice any kind of noise/smell before it stopped working? If the motor is burnt out - ...

...room temperature reaches this target once again, the fan will turn itself back to monitoring mode. I've attached our Getting started video below which shows how to adjust the temperature, using the ...

...room temperature reaches this target once again, the fan will turn itself back to monitoring mode. I've attached our Getting started video below which shows how to adjust the temperature, using the ...

...room, the fan does not work, it may be the wiring. You can have a handyman check this. If it works but only by wall switch, but not by remote, you'll need to check the settings on the dip switches in ...