Do you know if the 2003 Express Hi-Top Conversion Vans have had a on going problem with the rotors corroding or rusting out? I had to have the back rotors turned at 17,000 miles in 2005, and now they ...
Question about 2000 F150 Flareside SuperCab
...rotor will hit the same high spot no matter how many rotors you install. This is hard to catch because it takes the weight of the vehicle to bear down on the hub bearing. You may notice uneven tire ...
Question about 2000 F150 Flareside SuperCab
...a YIBOO AH 64 GYRO Apache HELICOPTER uj 722 with lights. I have a problem this item has one upper rotor and one lower rotor. the upper rotor operates. the lower rotor does not, I had the bottom ...
feels like brakes are vibrating. just wondering what the approximate cost will be to fix. Your rotors are warped. Depends on if rotors can be turned or have to be replaced. Turrn rotors would be under
...suspected sensor problem, got it replaced. But still the problem exists. It sounds like your front rotors (brake disc) are severely warped. This is caused from a hot rotor coming into contact with ...
when braking I get a pulsating vibration in front. We replaced the rotors and the pads but the problem is still there. What could be causing it? I was told that the rotors I got were a lower brand ...
...error codes 240 and 130. what does this mean? The fault codes 130 and 240 are pertaining to a Rotor Position Sensor problem. It is the part located wedged into the motor stator and it's
rotor will wear unevenly. (Also, pay attention to unusual rumbling sounds when cornering or sudden jerks while braking; these indicate possible wheel bearing problems. The jerking may be caused by the
Question about 2007 Freestyle Limited
...have at least 70% remaining. Alignment was good when last checked. Most likely problem is brake rotors warped. If you replaced pads without machining rotors, or if rotors are getting worn and ...
...problems in several ways. The E. brake material can jam inside the rotor/drum and the E. brake needs to be fully retracted to give clearance to remove the rotor. Sometimes the rotor rusts to the axle ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions