Question about GT-11 Non-Contact Voltage Detector
How do I change batteries on the GT-11 Voltage Detector How do I open the case to get to the batteries without a hammer? Hold the tester in your hand and you will see the on/off switch at the end of ...
Question about Gardner Bender GVD-505A LIVE-WIRE Adjustable Non contact Wire Tracer
How do I change the battery in my GVD-505A tester? Press down on the pocket clip and slide it off the end of the tester exposing two LR44 button batteries. Thank you that was very Helpful Takes two ...
96 xr6 battery reversed ,now will not start.. after being jumped started the wrong way round by towing co..Blew 100amp main fuse..Fitted with SMARTLOCK which fashes when trying too start. jump the car
washer fills with water will not run There's a little timer(round gold two wires are hooked to it) behind the top panel on your washer take it off and test it whit a ohms tester to see if it is faulty
We have a Fisher and Paykel Model #DEC27CW1 All of a sudden it stopped heating. Is there something we can check other than the vent, which is clear? Dryers work on two 120 volt circuits which is why ...
clean fillter light stays on getting no heat All models of dryers have two up to four sensors what is called heat cutout switch, normally if machine is turning one of those are damaged, it is a round ...
Slight tingle when I touch case. Noted that it only uses a 2 pin plug This is wrong, and could be dangerous. It could be caused by a faulty device, or by faulty wiring. You owe it to yourself and your
i have a 2002 bmwi with a code500. where is the vss What tester are you using for the code? is it the round black code reader, Peake? If so, go to their website for the code meaning. I do not have ...
how do i fix a horn on a 2003 saturn ion In under hood fuse block fuse number 20 /10A check it and check on the horn connector end if there is 12 V with lamp tester Check for a good round
Question about 2003 ION
I have moved and linked up machine to water supplier - but not coming into machine check hoses are the right way round,hot to hot cold to cold,if good remove cold hose from machine and turn tap on to ...
Usually answered in minutes!
918 Questions
300 Questions
107 Questions
109 Questions