Module RPS and Pump My Spart Dribe washer fault was traced to Module,RPS and Pump. Is this something that I can repair myself? huh?? doubt all three are bad pump can be removed and ckd ..lean washer ...
...and instantly stops please help I cant afford a repairman Both of you most likely are getting a "RPS Sensor Fault" On a GWL10, when the motor rotor position sensor fails, it will act exactly like ...
...down to number 130 it would tell you that the error message that you are receiving is due to the rps sensor in the unit and the solution would be to check your rps sensor with an rps sensor and ...
Question about IWL12 Top Load Washer
...mention in the manual but still the same. please help..... It is showing fault code 130 which is a RPS or Rotor position sensor fault, This is located on the motor stator under the washing machine, ...
Question about Fisher & Paykel Washer
Fisher and Paykel washing machine MW612 replaced the RPS but still wont agitate and lights 1 and 7 still illuminating HELP Is the motor wires(Red,Blue,Yellow) plugged onto the right place on the motor
where is the rps located on the fisher paykel gwl11 washer lean washer forwards, right onto it's front if possible. use a 5 / 8 socket to unscrew the large plastic motor cover. you can now see the RPS
what is fault code 130 and how do I fixit? 130 indicates a faulty Rotor Position Sensor (RPS) or a bad connection to the RPS. This can be a common fault on all Smart Drives. Rather than explain the ...
Question about IWL12 Top Load Washer
...do I fix error code 240 ? looking from the bottom of machine and don't know what I'm looking for? RPS sensor fault. You have to remove the rotor bowl then loosen the 4 bolts holding the copper ...
...up. Any ideas ? Regards Tom http://homenol.blogspot.com/ Visit this site to get some details. RPS (Rotor position sensor) is faulty. Mounted on top of the copper stator in the motor is an ...
fisher and paykel GW612 fault code 11110000 RPS (Rotor position sender) fault. The RPS is an electronic sender unit mounted on top of the motor winding. It tells the main control board what position ...
Usually answered in minutes!
1,514 Questions
200 Questions
88 Questions
87 Questions
45 Questions