Questions & Answers for: Chrysler rust problems

Question about 2004 Pacifica

2 Answers

...gears would cause the motor to jump....i would recommend taking it to a mechanic It also could be a rusted engine cradle Chrysler has a warrinty on 2004 and 2005 for 10 years 150,000 miles. Everyone ...

Ad

Question about 2001 Voyager

1 Answer

...off in 5 miles. Any ideas? I think some of senors at the wheels are broken and there are a lot of rust on the ring with small teeths which has damaged the sensor. You must before you change any ...

Ad

...burn up . sometimes last for one minute or less , take out the rear lightb assembly and check for rust on the connector.moisture will do that and since rust is iron,it will create a short.put a

...life is easy unless you enjoy what you have to do. So you need to strip both sides. Remove all hub rust.rotor mounting suface rust, pad and caliper rust, then machine or replace rotors and pads ...

Question about 2007 300c AWD Sedan New Cars

1 Answer

steering wheel and gas pedal vibrate at abot 35 mph. vibration gets worse on freeway when braking I don't want to imply you don't have your brakes serviced or your shop is less than ...

Question about 2002 Town & Country

1 Answer

...my oil said that the metal tubes that connect to the rear air conditioner on my 2002 T&C are rusting at the bracket and should be replaced. Very expensive quote. Will this be a problem or Im I ...

Question about 2004 Sebring

2 Answers

...problems. The left turn signal does not work when head lamps are off, and when head lamps are on they flash simultaneously with right signal as if hazard lights are on. What is this problem, how do I ...

Question about 2002 Town & Country

1 Answer

...#160; If not I bet its the latch.  This is pretty common on these.  Also I have seen when rust will build up on the hatch lift supports.  The door will pop when it opens  Just ...

the brake lines on my 1998 Chrysler T/C van have rusted apart where the two incompatable metals have been welded together. This is also a common problem on the vans which Chrysler is aware of but has ...

Question about 2011 Town and Country

1 Answer

...installed or the parts were installed with improper lube on the slide assemblies and there is dirt/rust causing the pins not to move freely or the pad shims are old and rusted causing the pads to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...