Questions & Answers for: Chevrolet Uplander LS rust problems

SHAKING AND KNOCKING NOISE IN CITY DRIVING TURNING CORNERS OF ON AN UNEVEN ROAD MY FRONT END SHAKES AND I HERE A KNOCKING NOISE. IF I GO IN A PARKING LOT AND DO LEFT TURNS MY WHOLE STERING WHEEL AND ...

My power sliding door won't close all the way, door alarm keeps r We have replaced the door seal once and now the problem is happening again. Even if the switch is off on the overhead panel, the alarm

abs system light is on service abs system light is on My van had the same problem and it was a loose pigtail or plug on the wheel speed/abs sensor. Bought a new pigtail and rewired it, $5 for the part

...alternator . please help sir try to check ground connections Replace the gas cap - I had the same frustrating problem but my van NEVER stayed cranked unless I fiddled with the gas cap a few times. ...

Everytime I hit a bump the rear end slams into the frame. New shocks and a check of the springs show no problems. GM dealership said no problems,...but the there is a problem...the darn thing is ...

2007 Chevy Uplander LT cooling (radiator) fan is on all the time, from starting the engine on, until a few minutes after turning the engine off. Engine temperature is OK. No warnings on the dash. The ...

the security or door alarms wont shut off on 2007 chevy uplander van Had the same problem with my 2006 Uplander.Sanded the door contacts and the pins with 80 grit emory cloth.They get a glaze on them ...

07 uplander. abs/traction control/stability control service light comes on intermittently most often after idling for a few minutes. A reputable repair shop replaced both front bearings thinking this ...

07 chevy uplander transmision slips at take off from stop transmission fluild valve had been changed at 70000 miles trans flulid changed at 50000 miles no slipping for for 15000 miles then started ...

rust build up in the crank shaft I'm not sure you understand what the crank shaft is. It is an internal rotating part of the engine. Although it could possibly rust, it would be very difficult to see ...