Sharp 17" TV On a few channels a black rectangular box appears after the set has been on a short period, less than a minute. You can switch channels and come back and it is ok for a few seconds, then ...
...Sharp when switched on will initially go to HDMI input but after a few seconds will switch to Channel 3 Analog. The HDMI comes from a SA HD Explorer 8300 and is through a Pioneer Rx with HDMI ...
Sharp LCD TV picture goes off few seconds after power on. When I turn on the TV picture comes on and than screen turns black but the sound stays on. After power up I hear a click like a relay ...
Question about Aquos LC-32G4U 32 in. HD-Ready LCD Television
...Sharp Aquos LCD TV just switch off on its own after few seconds I switch it on... Had tried on and off few times, but the problem still persist.. Look at the power supply first; look for burnt parts, ...
...few second and then it switch off and the TV remain off. It's 3 years old. Thanks in advace for your help. Sergio if the T v off it give stuck noise for a second than off.it means the problem with ...
Question about LC32D44EBK 32 in. LCD TV
...few seconds tv is powering on and then switching automatically to stanby mode Hello, Power supply board have problems,just not dead yet.Replaced the power supply board,will solved this problems.Tries ...
...sharp lcd37d44 tv on, it comes on for a few seconds then everything goes off and the power light begins flashing steady every second. Probably, the switching supply of your TV cannot sustain power ...
Question about Aquos LC37D44U 37 in. LCD HDTV
my sharp tv/friendly series automatically turns off after a few seconds sharp friendly series/ 21inches check switching thanks .
Sharp TV's Stand-by Mode (Red), Model 14V-K80M, turns ON, turns GREEN when the other button is pressed but turns back to RED after a few seconds. Hi Your tv set may have an overload in the supply line
Question about 27H-S60 TV
...sharp lc-32a37m lcd tv it switch on but only stays on for a few seconds then it goes on stanby could it be the power supply Chances are good its the power board..you can test the voltages after it ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions