...You are not going to like my solution because I feel that for problems like this the set must be analyzed not just subjected to "shotgun troubleshooting", so here I go, Take the TV to a repair
Question about 55H70 55" Rear Projection Television
Theory of Operation for 55H70? part two See my original post, plus Techman's helpful first step in the thread "Theory of Operation for 55H70?" This is the convergence screen in 480i mode now. 1080i ...
Question about 65H81 65" Rear Projection Television
repair this TV, I would get more enjoyment hauling it to a field and blasting it multiple times with a shotgun. it is a good tv over all, so I think is worth fixing. because when it works, it give out
...installed it (thinking my original one was th prob) but same results.please help me before i take a shotgun to this p.o.s. toshiba Try burning at a slower speed and try +r if using - R or visa versa ...
Question about 53H71 53 in. Rear Projection Television
I was told by repair shop that the hyper module on my Toshiba 53H71 has gone bad, and they were not available for unit to be repaired . Any help ? there are a few shops that can physically repair ...
I sent my computer in a week ago for repair no word from toshiba on repair We can't help you. If you sent it to Toshiba, contact them. Hi. Sometimes it can take much longer than a week to repair ...
bootmgr is missing To repair missing corrupted system file/s, boot up with the Windows installation CD then – Press R to repair when instructed. Press 1 or Enter to repair the C:\Windows folder. Then ...
bootmgr is missing To repair missing or corrupted system file/s, boot up with the Windows installation CD then – Press R to repair when instructed. Press 1 or Enter to repair the C:\Windows folder. ...
Question about 22 inch full hd led tv 1080p 300cd m2 16 9 built Mfr P/N
How can I fix my tv Colour fading from top and bottom of the screen Unless you have a degree in electronics. or you are a skilled electronic repair engineer, I don't think you can repair this one. And
...shotgun approach, Re-Flow the solder on every component on the bottom side of the board that is through-hole (meaning the part goes all the way through the board as apposed to the really tiny parts ...
Usually answered in minutes!
405 Questions
364 Questions
299 Questions
263 Questions
243 Questions