clunk or rattle in front end purchased car new never smashed only happens when you hit bumps You should check your front end, ball joints and tie rod ends for play. To do that jack the car up and set ...
power steering shuts off If it makes a "howling" or "grinding" noise it's most likely just low on fluid. The "pot" is on the fender well under the hood. Check and fill. If it's empty, after adding ...
it says coolant below norm thermostat operating temp i have been watching the temp in the morning it takes a while but gets up to temp how do i check the temp sensor? its an ohm reading you would need
location of evap solenoid The Evap Vent Solenoid is located on the evap canister under the rear of the car near the fuel tank Here is a video that might help you. Its for an impala but it should point
Location of crank shaft position sensor in a 2008 chevy cobalt http://www.youtube.com/watch?v=RTGaI2Ug_Qo
tools needed to change front brake pads https://www.youtube.com/watch?v=qzvPKrrLzuc https://www.youtube.com/watch?v=gAU0oqG30jU ...
When placed in D(rive), why doesn't it move? 2006 Chevy Cobalt Transmission Control Module failure ... ? 3:07 www.youtube.com/watch?v=tSbfdlGZwHM Jun 29, 2010 - Uploaded by Nickocosmicfatplanet While ...
Question about 2007 Cobalt Coupe
My Chevy cobalt 07 sticks in park n won't go in any gear ...what is problem Sticks in park and won't go to any gear ....where/what is problem? Problem with the shift interlock system .Watch this video
Where is the knock sensor on a 2010 Chevy Cobalt https://www.youtube.com/watch?v=My62LFISUds
2006 Chevy Cobalt how to remove the starter https://www.youtube.com/watch?v=l0tZlBwmEUg
Usually answered in minutes!
1,428 Questions
818 Questions
485 Questions
212 Questions
74 Questions