...solder wick to soak up the errant solder, solder wick, is a braided copper string designed to collect melted solder, simply apply the solder wick to the aggregated solder and melt, the wick will soak ...
...solder wick to remove the old solder. You need to heat up the old sloder with a solder iron and while its molten touch the solder wick to the solder and the wick will absorb the old solder. You will ...
...solder wick. Solder wick is a fine copper braid that soaks up solder as it melts, leaving the connection clean so you can remove the old part. You also need an appropriate soldering iron and solder ...
...of the same diameter wire. You are better off replacing the capsule. Hope this helps. I used some Soldering Wick to solder the coil wires to. I was then able to solder larger gauge wires to the
Question about 57H81 57" Rear Projection Television
...wick on the solder connection and then place the soldering iron tip on the wick. Wait until the solder is sucked into the wick and completely clears the connection of any solder.Once both connections ...
...solder wick' to remove the existing solder when you take out the duff caps. This is used by placing the solder wick over the joint and applying the soldering iron to the solder wick. After a short ...
...skills. get some >>solder wick and a soldering iron and some solder... heat up contact point with iron while wick is between iron and lead of cap....wick will soak up the
...solder wick. Use the wick and the iron to remove the solder off of the legs of the cap. Remove the cap. Install the new cap exactly the same direction the old one was in. With solder and iron, solder ...
...solder wick. Chem wick makes the best solder wick. DON'T buy the solder wick from Radio Shack. Take a non Metalic item lke the handle of a screwdriver and tap around on the bottom side of the PC ...
Question about Magnavox 37MF231D 37 in. LCD TV
solder wick and solder. Apply heat with the iron to the lugs on the input that protrude through the circuit board, and apply solder wick to desolder the bad part - do this for all the contacts. Remove
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions