Questions & Answers for: Dodge solenoid

...pinpointing problem Causes The causes for a P0403 EGR code could be any of the following: Bad EGR solenoid Excessive resistance in control circuit (PCM controlled ground) due to an open, chafing or ...

...failures often cause this code and are a common failure part on WJ Grand Cherokees P0750 Shift Solenoid circuit. Note: If code P1767 (Transmission Relay Always On) is also present: Replace ...

...1993 Dodge Dakota - truck won't start, starter has been tested and is alright, can jump over the solenoid and will crank, but when starter is reinstalled, it will not crank when you turn the ...

...could be (i) low fluid in the torque converter, (ii) a faulty signal to or from the torque clutch solenoids, (iii) a crack in the torque lock up solenoid pipe leading to fluid pressure loss, or

...with the key on.Set Condition: This code is set if the voltage detected on the Governor Pressure SolenoidControl Circuit at the PCM is different than the expected voltage for 4.8 seconds.POSSIBLE ...

what does the code po753 refer to Symptom:P-0753 TRANS 3-4 SHIFT SOLENOID/TRANS RELAY CIRCUITSWhen Monitored and Set Condition:P-0753 TRANS 3-4 SHIFT SOLENOID/TRANS RELAY CIRCUITSWhen Monitored: ...

403 RAM 2004 error P0403 code?The Exhaust Gas Recirculation (EGR) system is controlled by a vacuum solenoid. The solenoid is supplied ignition voltage. The Powertrain Control Module (PCM) controls the

...causes- Low transmission fluid level - Dirty transmission fluid - Faulty torque converter clutch solenoid valve - Torque converter clutch solenoid valve harness or connectors - Torque converter ...

...Hi there:P0403 - Exhaust Gas Recirculation Circuit MalfunctionThe most common failure is the EGR solenoid goes bad. The code will not set and turn on the light until the car's computer

...a 2000 Dodge Durango 5.2 with P0753 code can anyone tell me which wires the Pcm uses to ground the solenoid so I can check if the path from Pcm to ground is good. Already changed solenoid still have ...