Questions & Answers for: Jeep Grand Cherokee solenoid valve

...solenoid valve in the transmission. To test this code accurately, you would need to have Chrysler connect their scan tool to it. With that, they can check the whole system. The governor pressure ...

Ad

Question about 1997 Grand Cherokee

1 Answer

...valve body. Replace the governer solenoid they get gummed up after a while. Clean out the valve body by shoot air pressure through the check holes. Replace the trans filter and refill the trans will ...

Ad

...solenoid located inside the trasmission, in the valve body. The throttle position sensor must replaced. If the problem is still there, check the transmission switch solenoids and valve body, and the ...

Question about 1999 Grand Cherokee

1 Answer

...transmission bolted to the valve body. You have to remove the bottom pan to get at the solenoid. The 3-4 shift solenoid and the Torque converter clutch solenoid and built together on the same

Question about 2000 Grand Cherokee

2 Answers

...valve Evaporative Emission Purge Solenoid Description & Operation The duty cycle EVAP canister purge solenoid (DCP) regulates the rate of vapor flow from the EVAP canister to the intake manifold. ...

Question about 2005 Grand Cherokee

1 Answer

...solenoid valve pressure modulation occurs in three stages, pressure increase, pressure hold, and pressure decrease. The valves are all contained in the valve body portion of the HCU. PRESSURE ...

Question about 2001 Grand Cherokee

1 Answer

valve. The pumping cycle is repeated as the solenoid is turned on and off. When the evaporative system begins to pressurize, the pressure on the bottom of the diaphragm will begin to oppose the spring

Question about 2004 Grand Cherokee

1 Answer

...valve body Remove governor body gasket. INSTALLATION Before installing the pressure sensor and solenoid in the governor body, replace O-ring seals, clean the gasket surfaces and replace gasket. Place ...

...solenoid valve - Shift solenoid valve harness or connectors - Shift solenoid valve circuit is open or shorted so what is your question, the A/T is one of the most complex and finicky devices, ever ...

Question about 2003 Grand Cherokee

1 Answer

and what other parts will i have to buy to do the job You shouldn't have to remove valve body, the solenoid should be on the valve body, held in by a single bolt, with a wire plugged into the solenoid

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...