Question about KAC-9152D Car Audio Amplifier
...sony amps. if they are ogood...next try hooking up each amp individually...if they will turn on seperatly but not at the same time it could be due to over abuse of the single ground and power leads ...
...sony ,in dash gtx500 and a kenwood mono amp ,, i have a big time ,proplem with the tuning , to get the most and best sound , where do you start to tune and set all the adjustments.............thanks ...
sony was it did not have a remote wire for my amp so i ran the remote wire to the yellow wire it was on all the time until i hooked up a toggle switch. but now the yellow wire seems to not be working.
...Sony SEN - 770 amp enough clearance and overheated. There are 2 125 volt 8 amp fuses. Amp won't come on at all. Could it be the fuses need replacing? Yes, try replacing the fuses first. If that ...
...What can I do to fix it? i have the same amp with the same problem.....your best bet is to do what i did get a better amp(audio pipe,spx,kicker,punch,etc) do not get pioneer amp or sony ...
...amp indicator is blinking blue and my sony xplod sub is not workin thru the amp but works wen i connect it in my other car how do i fix it so my light stops blinking, and my sub works again yes you ...
Question about Kdc-bt645u Car CD/ MP3 Player
...Sony deck in this car with the deck above ,most of the wires matched up to the factory plug .The deck works fine BUT the power antena does not work? I checked conductivity on the blue wire from the ...
...sony amp pushing 540 rms in a vented enclosure and the other set is being pushed by the kenwood x1200m in a sealed box at 4 ohms it should be pushing 800 watts rms...the movement of the subs being ...
Question about VR-407 Receiver
...SONY and is not powered would that have anything to do with it? yes it very much has everything to with it. your sub out is at a pre-amp lvl, so you can route that signal to another amp, then to your ...
...sony would bump hard but with this new deck my subs barely work and I've messed with the settings on the deck itself. I unplugged the rem blue wire from the amp and my deck went black, it only stays ...
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions