...FREE SPACE MAKE MORE FREE SPACE IN PLAYER DELETE FEW SONGS. get a needle and hit the reset button on the back. That should fix it -D-Vice- Get a needle and push the reset button located on the
...Space needle woodcraft construction kit 3d puzzledo not give any detail as to what pieces fit to in relation to other pieces just what reference to the front picture gives and the individual pieces ...
replace the needle, make sure you do not push the new needle all the way to the dash, there should be a small space between the dash and the needle. That's exactly what I had to do to my 2002 Windstar
Question about 2003 Windstar
a different stitch length. If the ruffler foot is installed correctly and needle is in the correct position this should not happen. It is hitting left/right/forward or back of the ruffler needle space
Question about 2003 Windstar
...needle positions are permanently set on a serger. You are unable to adjust the distance between them because there is a timing issue involved. There are some sergers with more than two needles, so ...
needle, the space in the presser foot and needle bar need to wide enough to accommodate the width of the twin needle. Also, you will need to use two spools of thread--so you would have to "make-shift"
Question about 2003 Windstar
Euro-pro ep382 sewing machine-- top thread from needle won't pickup thread from bobbin? If you think the machine is threaded properly and needle is good, then remove the plate and check the timing and
Question about 2003 Windstar
this happen. I have a pfaff coverlock 4872 Perhaps you have overly loosened the screw. Try tightening it back a bit. Sometimes when it is overly loosened it changes the angle in the needle clamp space
Question about 2003 Windstar
...needle with narrower spacing between the two needles. This can help alleviate any interference with the throat plate. Double needles come in various sizes, so choosing a smaller one might provide the ...
Question about 2003 Windstar
needle bar number , then a zero, a space, then another zero. What is going on??? It sounds like there may be an issue with the needle bar position counter on your Tajima TMEX machine. This counter may
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions