Question about NAV5800A Top Load Washer
...clothes through the final spin cycle twice before they are dry enough to put in the Dryer. Red Ryder, the motor is 1 speed on this model. A couple of things to check; one would be the belt. Look for ...
Question about NAV5800A Top Load Washer
clothes on the first spin. Always have to spin twice to extract water. Never any water left sitting in tub after first spin. I have replaced direct-drive coupler and the pump. No change. The tub seems
...spin my clothes twice Why do I have to spin my clothes twice before the water comes out? When the clothes are wet at the end of a cycle, check these: Motor coupler Spin cycle Siphoning Water-inlet ...
clothes are still wet after a spin cycle in my front loading washing machine You can do any of these things. use less clothes use higher heat setting dry clothes twice or CLEAN THE LINT FILTER
...twice as long to dry clothes Hotpoint ultima condenser dryer TC71 no longer heats up although the drum is still spinning Takes twice as long to dry clothes See this thread. ...
...washer, are the clothes real wet after the cycle is done, they should not be that wet after they spin, if it was me I would spin them twice or see if there is a option to spin longer if they seem
Question about Nexxt Premium WFMC6400UC Front Load Washer
...Same thing twice more. Unplugged it twice. Tried every cycle. Will not spin, drain, or open. Our clothes are held hostage. What do we do? if the error code is SE it needs 2 be manually ...
Question about Ultimate Care II LSQ9564J Top Load Washer
..."clicks" and shifting the machine back and forward. This sometimes works and I get a normal spin and the clothes are properly wrung out. What could cause this? I appreciate your help. clean your ...
...spin the clothes good and will have to spin twice. I replaced the"dogs" and since then makes a little noise,dont think they were pit in correct.WIll this cause the clothes to not all spin? Does it ...
Question about Ultimate Care II LSQ9564J Top Load Washer
spin speed, the clothes may be too wet at the end of a cycle. Check to be sure the load is properly balanced and run a spin cycle again. If the clothes are still wet, you may have a worn or loose belt
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions