Questions & Answers for: spin solenoid

Question about WSKS2060WWH Top Load Washer

1 Answer

...spin coil/brake solenoid is burnt out or broken. This is a coil situated on the motor plate under the machine with a lever attatched to it. When the machine goes into spin cycle, this solenoid pulls ...

Ad

Question about Ultimate Care II LSQ9549L Top Load Washer

3 Answers

...spin solenoid is mounted on top of transmission , when plunger on solenoid is activated it drops the clutch and spins , if the solenoid is bad then it wont activate the solenoid , to test to see if ...

Ad

...spin at all, it will fill and drain fine anyone have suggestions? My GE washer is not spinning I want to check the solenoid where is it? hello mam if your machine is not spinning then its not the ...

Question about 24902 Top Load Washer

1 Answer

...spin solenoid. This is normally done through a gray wire from timer to lid switch and then a red wire from lid switch to the spin solenoid. A white common wire completes the circuit. This spin ...

...solenoid when the usnit is supposed to spin. This in turn pulls the actuation arm reaward allowing the spin tube to drop the clitch pads onto the drive plate. If the solenoid is bad or the gliding ...

Question about 1997 Bravada

2 Answers

...solenoid. If the starter does not spin, or turns very slow, however, the starter is dragging and needs to be replaced. Take care and good luck Battery is most likely the issue. Check the terminal ...

Question about 1997 Bravada

1 Answer

whirlpool washer wont spin out put washer in spin cycle on close cover you should hear click if so check cutter pin on rocker solenoid no click wire to solenoid or solenoid or switch on cover door

...solenoid only makes a clicking or clunking sound. They do not spin. You must be hearing the starter spinning but the starter gear has not engaged with the flywheel. That's the solenoid's job. It must ...

...solenoid engages but doesnt spin.with switch in run pos.i can use screwdriver across terminals on solenoid and get sparks but still no spin.only way it starts is to have someone hold switch in start ...

...problem and if it doesn't spin the problem is the latter. Use a test lamp to check if the thin wires have current and to identify the solenoid wire and verify the operation of the starter

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...