Questions & Answers for: stall at idle

Question about 1988 Cavalier Z24

1 Answer

...idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 ...

Ad

Question about 1996 Grand Cherokee

3 Answers

...fluid,the motor will stall when fluid is low Replace the idle air control (I.A.C) motor on the throttle body chk and change complete throttle body with tps and idle motor also chk vaccum ...

Ad

Question about 1999 Cougar

1 Answer

stall or idle at a low RPM around 400-500. To start i have to put foot on the gas and keep it at about 1500 rpm and easily let off gas so it wont stall, if i just let off gas it stalls until engine is

Question about 1989 200

2 Answers

...idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 ...

idle problems, when stopping car stalls, sonetimes idle problems, when stopping car stalls, restarts easily but need to keep foot on gas to prevent stalling whil braking, sometimes idle races ...

Question about 2008 Trailblazer

2 Answers

idle the engine, but not enough to keep the engine running when put into gear. There is a demand for more fuel when the vehicle is put into gear, if the fuel pump is unable to keep up with this demand

...Check the help link mentioned below to troubleshoot the problem: ------ Engine stalls when gas is given? ...

Question about 2006 Cobalt

1 Answer

2006 cobalt stalls and idles rough the car stalls when stopping or after a long run cant put it in reverse because it stalls out.. check idle control valve if bad idle too low car will stall

...stall when idling - only sometimes. A few times the idle has shoot up to around 2.5 revs while in drive - when I am just going at idle speed or a bit higher. Turning off the car and back on again ...

stall at idle could be from a low idle ( the idle may have to be relearned using a shop computer). You may have a vacuum leak on a hose leaning out the motor and causing a stall. I would scan test the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...