stalling at lower speeds and when the AC is turned on, you can clean them with a can of throttle body cleaner from any auto parts store, carb spray will work as well, have someone hold the engine at a
Question about 1988 6000 Wagon
...lower speeds basic tune up was done 6 months ago, didn't help the prob. 3 days ago, car stalled after 30 mins. driving, restarted but stalled when attempting to drive. waited 20 minutes, car started ...
...stalling that I have ever dealt with. they will cause some issues but not at high speeds. If you have NOT replaced the CRANK sensor....REPLACE IT NOW. It is known to fail often and cause stalling ...
...lower speeds and for stopping. If it doesn't unlock, the car will stall at a stop. Try putting it into neutral (carefullly, so you don't go into reverse) as you slow down, if it doesn't stall out, it ...
for 5-8 minutes then slowly starts to slow in speed until it quits. duration to stall in the lower 2 speeds is much faster. Help!!!!!!!!!! Needs oil. Hopefully the bearing are not completely shot. :o)
...stalling while other days it may stall 4 times within 10 miles. Has not stalled at lower speeds such as 40 and below mph. Thanks hi can you have it scan for a dtc code to know what the problem is or ...
Question about 1996 Legacy
stalling at lower speeds. That is, anything over about 50km/h, and the speed and revs can begin dropping steadily. My foot stays on the accelerator in the same spot, but it doesn't rev like it
Question about 2003 F250 Super Duty Crew Cab
...stalling at idle. I need to know if this is actually a bad speed s also the truck is acting like it cant shift properly in lower speeds, escecially between 40-50 mph. The sputtering has almost gone ...
will idle control valve make car bog out while in drive Yes, but only at very slow speeds, 5 mph or lower or at idle, if it stalls at higher speeds there is another problem.
...stalling at lower engine speeds. 2) Is there a vacuum leak at the engine? A vacuum leak can also cause stalling at lower engine speeds, depending on the severity of the vacuum leak. 3) Has anyone ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions