Question about Garden
...THE RUBBER PULLER TO STOP THE CORD FROM PULLING BACK THROUGH THE HOLE. rELEASE THE LOOP IN THE CORD NEAR THE COVER HOLE THAT YOU PUT IN AND LET THE SPRING WIND THE CORD BACK IN TO THE STARTER ...
...the starter, HOWEVER they do stock starter cord which is sold by the meter. What mm cord should I purchse for my mower 3mm, 3.5mm, or 4.5mm? take your cord with you and get something similar in ...
starter cord won't rewind The starter cord is spring loaded. When the spring breaks your cord won't rewind. Usually the whole starter cord assembly is easily replaced and readily available at your ...
...starter mechanism and have them rewind the cord for you if you don't feel comfortable about installing the new cord. When done, just reinstall the starter on the saw and attempt a start. Good
...starter, if the cord is still under tention, pull the starter handle out approx 8", whilst held out hold the pulley to stop it retracting, let go the starter handle and unwind the now lose cord from ...
Question about Chain Saw 20" Bar
...starter cord on the motor, manually push it in the opposite direction to the spin created when the cord is pulled. You need to pull the cord sharply to deploy the clutch so it engages the motor. If ...
...cord? starter cord frayed Hi James: Replacing any starter cord is usually a matter of removing the pull start assembly, pulling the cord until it is completely unwound, block the reel so it cannot ...
...starter cord on mt coleman ct200u Remove cover over starter pulley. Cord wraps around this. When cord is pulled, centrifugal force swings spring-loaded weights out, to engage the starter gear. Check ...
Question about Chain Saw 20" Bar
...starter cord snapping back and pulling out of your hand on a Briggs 10 horsepower engine: Weak starter spring: The starter spring may be weak or broken, causing the cord to snap back with more force. ...
Question about Chain Saw 20" Bar
Cord: Flip the starter cover over and replace the pull cord. Make sure it's securely attached to the pulley. Reassemble the Starter Assembly: Put the starter assembly cover back in place and secure it
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions