Question about 2005 CBR 1000 RR Fireblade
installing a new stator on a 2005 honda cbr1000rr Do you know for certain that the stator is bad? Quite possible of course, but the R/R is a much more common failure. The R/R used on later gen CBR1000
HOW TO REWIND A STATOR THAT WILL LAST FOR AT LEAST What's the best way of rewinding a stator for XL 125S so that it will last longer and how to do it..this is my second time to have my stator rewinded
i need to fit a new stator to my CBR 600 FS1. How i need to fit a new stator to my CBR 600 FS1. How do i do this ? The stator is bolted to the left side cover. Remove the cover and you have removed ...
How do you test the stator output/function? I have a volt/ohm meter. First, set the meter to read AC voltage at a range of 100 or better. Next, make sure the stator wires are clear of anything that ...
...coming out of the back of the motor and follow it to the plug with three yellow wires. This is the stator plug. You should have continuity between any combination of the three yellow wires, but no ...
how to check stater on 1992 honda shadow Locate the wire harness coming out of the stator on the left crank case cover of the motor and follow it to the plug with three yellow wires. This is the ...
Question about 1997 CBR 900 RR Fireblade
will my 97 cbr 900 run with the stator unplugged? just got this bike. guy says stator is bad! stator was unplugged when i got it. will the engine run with a charged battery and not plugged in to the ...
My bike is not charging Stator - check 3 yellow wires if they have resistance between them, (they are coming from stator), reading should be the same, if not, you have a bad stator. This bike doesnt ...
stator test is the stator on a honda cbr 1000 the same as a stator on a honda cb 650? Most likely no. While it is possible, these are very different bikes, with different crankcases and bolt patters ...
Question about 1997 CBR 900 RR Fireblade
1979 Goldwing GL 1000. How can I install a new stator? Here's a general guide to help you with the process: Prepare the Motorcycle: Ensure the motorcycle is on a stable and level surface. Disconnect ...
Usually answered in minutes!
188 Questions
186 Questions
195 Questions
148 Questions
151 Questions