Question about HC900U Multimedia Projector
...lamp or what? Thanks. your projector status means the protection circuit is working or the lamp is in an abnormal condition. --wait until status indicator goes out and press power button. ---if the ...
...lamp The status indicator lamp blinks it's 6 sec cycle. As described in the manual, this indicates Lamp Error. When we try the troubleshooting suggestion of waiting one minute and turning it back on, ...
...does it say anything about a slow blinking green lamp indicator, much less both the lamp and status indicators blinking at the same time (green and yellow). What can I do? Lamp is bad need new ...
...lamp indicator goes out. Same blinking status light. I replaced the bulb and tried again, same blinking status light. I checked the filter, etc. This projector has not run for 2100 hours, so the bulb ...
Status Light Flashes Red Repaced lamp 2 weeks ago everything went fine. Last night fell asleep watching I woke up an the set was off and the status indicator is flashing red. I turnern power off at ...
Question about WD-62525 62" Rear Projection HDTV
lamp status" for Mitsubishi wd62725 I just replaced my lamp and yellow light is still on. Owner's manual says "lamp status" reset instructions are on page 63, but no information re "lamp status" reset
...lamp status lights Mitsubishi XD 300 U won't project, power light blinking red/green, and lamp status light blinking also,, what do I do to make this thing go? ...replace the lamp. The lamp is most ...
...status light and no lamp The projector will turn on and the start up process is normal until the light should turn on. Then status light which started out green begins to flash red. The lamp does not ...
Question about WD-62825 62" Rear Projection HDTV
...out (indicator goes to constant red status). Replace lamp (get lamp P/N from User Manual for replacement), clean any dirt around lamp, fan, and rear filter. Do NOT get any fingerprints on new
Question about WD-62825 62" Rear Projection HDTV
Status 3) Lamp If "STATUS" LED is blinking RED: 1) Internal Fan has stopped. These tv's require fans, to prevent overheating and causing damage. If "STATUS" LED is solid RED: 1) Circuit failure (short
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions