...steer tube. Measure twice - you don't want to cut it too short. You can always cut it again or add headset spacers. For a threaded fork, you will need to allow room for the headset and a cable hanger ...
Question about 1992 GL 1500 Aspencade Gold Wing
...fork oil level and torque specs for the tube pinch bolts and steering stem bolt? Fork oil capacity should be 10.9 oz in the left, and 10.8 oz right. Lower pinch bolt torque is 40 ft-lb and upper is 8 ...
fork. There are three standard steering tube sizes: 1"; 1.125"; 1.5". The 1" is found on budget bikes, older bikes and some cruiser/hybrid bikes. 1.125" is the most common size and is also usable on 1
...fork tube. Then take the large "nut" off the tube at the top triple tree. You may have to drive a chisel into the slot on the lower triple tree from the bottom side to spread it a bit. Then work the ...
Question about 2005 FLSTC - FLSTCI Heritage Softail Classic
...fork tube from the steering head and the other, simply remove and replace the lower slider. There really isn't that much difference and I prefer to remove the entire fork tube myself. First you'll ...
...fork tube clamps back into alignment is relatively straightforward, though straightening them out may also reveal bends in your fork tubes. The easiest way to get these into alignment is to remove ...
Question about 2005 CB 250 Nighthawk
...tube of the fork, you must take them apart for repair.If the bit of play is between the tube and the yokes (triple tree) of the steering then sure you can tight the yoke's bolts in specified ...
...forks fit a Yamaha maxter xq 125 just measure your fork leg diameters and compare them to the yz ! you could also see if the yz fork clamp headstock bearings and steering tube will fit your bike
...fork tube and then using the fork tube like a slide hammer drive the upper bushing, seal and spacer out the top of the slider. While apart you should also inspect the rings and bushings etc. You will ...
fork tube caps. 8. Loosen all pinch bolts on top and bottom triple clamps and pull fork tubes from triple clamps. 9. Remove brake hose bracket from the bottom of fork stem and bracket. 10. Remove fork
Usually answered in minutes!
165 Questions
193 Questions
115 Questions
114 Questions
96 Questions