Question about DUAL CASSETTE A/R 110/220 Single Dual Cassette Deck
stretch the belt and is slooooooowly comes back, then the rubber has turned to licorice. If it If your belt has already stretched and it is still in one piece, when you measure it, it will be too big.
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...belt to stretch to the large wheel and the belt just seemed to short??? I purchased the flat belt from Hoover that says for wind tunnel, self propelled??? The belt number is 38528035 and it will ...
...belt tighter? Do they really just stretch out like that normally? The flat belt has never been replaced and is in great condition. It is the flat belt that gets stretched and should be replaced at ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
...belt they stretch out. Think of a belt like a big rubber band if you were to stretch it out and hold a lighter to it the rubber band would stay stretched out. That is the same thing that happens when ...
Question about U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum
mach 4 burning smell There are two reason you could be smelling a burning smell- 1. The belt is too stretched out and needs to be replaced. This causes it to slip when the vacuum is on and will create
...stretch the belt around the inner (botom side inner) lip of the platter - you should see the motor facing up with a brass capstan or drive bobbin -from the top side of the platter stretch the belt ...
...belt they stretch and lose elasticity . The belt may be intact but it still can be stretched. If the belt is stretched it will slip and will not turn the brush roll against the resistance of the ...
Question about PX-E860 Turntable
...Having trouble getting the belt to stretch from the brush to the motor pulley. Is there a trick to stretching the belt to fit? hi ,try warming the belt up in hot water first it will stretch ...
Question about PX-E860 Turntable
...my Magnavox EC9355 BK01 but speeds are way too fast. It was playing normal until the original belt stretched out and played too slow. Any ideas? How to Correct Speed of Newly Installed Turntable
Question about PX-E860 Turntable
3 of them) is to pull the brush out, put the belt on the spindle shaft, then onto the roller, the you can stretch the belt with it already in place and lower the roller into place. The belts are stiff
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions