Questions & Answers for: AudioBahn subs and amp

Audiobahn Sub: AW1206T & Amp: A8002T subwoofer extra noise/pop Ya now i dont know if its from the amp or not but amp light is on & ther is no short circuit or anything like that.... the sub was ...

...how do you fix that problem. Cuz i have the same problem too. I hook up one 10 inch sub and it works but when i hook up the second one the red light on my amp comes on. Both subs used to work

...subs in parallel. Bridge the amp to one channel.This should max the amp out at 2400W, which means about 1200W per sub. If your subs are single 4 ohm voice coils, do the same steps, but you'll only be ...

subs and 2 if the amp is mounted on the box it is vibrating the electronics loose. you always want the amps rms power to be be about 25% more than the speakers rms rating, from the sound of it you are

amp can blow a 800 watt sub dc voltage is not good for subs also up all the way can burn out the internal battery in the amp lets hope thats not it just make sure ground is good protection light means

amp works fine because I have back up subs connected and are working. I hooked up my meter to the + and - and do not get a reading but when I hook up the + and touch the metal frame on the back of the

amp that accepts two subs then the sub can be bridged to both outputs on the amp but you need to be sure the your sub can handle the output wattage from the amp or you can kiss ur sub goodbye. I would

...subs to a A1300hcq amp The amplifier is only stable to 2 ohms. Assuming the cubs are dual 4 ohm voicecoils - a 2 ohm load with 2 subs is not possible. You can only wire up 1 dual 4 ohm voicecoil sub ...

...subs my amp keeps kicking into protection whats my wiring opions mono amp adnot sure what ohm the subs are Hey sound like your amp is seeing to low of indapendece. 3 subs can be hard to wire. please ...

I have a audiobahn aw1251t 12 inch sub and punch 1000-1db amp how would i wire it up as your sub is only rated to 400w rms simply connect the sub to either a or b channel outputs you may wish to use ...