...sustain board all and power everything on again i'm unable to measure any voltages on any parts of the boards. any help would be greatly appreciated thanks fyi - the big cord i was talking about is ...
Question about Vizio P50HD Plasma Television
...sustain boards or the mainboard. Most likely it is the Y sustain board but it is recomended to replace Y and Z sustain boards if one is damaged. You would need to have your firmware flashed on the ...
...sustain boards, because there is no easy to isolate the problem. The easiest way is to swap boards till you find which one is bad, and this gets expensive. The buffers range from $75 and up, and the ...
Question about 42EDT41 42 in. HD-Ready Plasma Television
The "sound, but no picture" problem is common for plasma tv's. I fixed mine buy replacing both the Y-sustain board and the Z-sustain board. You can find both boards on ebay for around a total of $150
Question about 42PC3D 42 in. Plasma Television
...direction is appreciated. This condition, sound no picture, is generally a result from a failed y-sustain and/or x-sustain board. You can check the fuse for continuity or resistance using a ...
Question about 42PC3D 42 in. Plasma Television
...boards are cheap and fail quite easily (both the two sustain and the buffers) Philips service manuals are more oriented at board swapping then at proper testing. In this particular case the buffer ...
...sustain boards, but stiil the picture is fuzzy;moreover, the new z sustain board just blew from a C3 with red cap gushing silver liquid. To give you a little back story the P2 connector that goes to ...
boards. Maybe you damage the Y Sustain because the Y drives weren't good. Try to replace the fuse, disconnect the Ydrive from Y Sustain, turn on TV and check for voltages on Y sustain (panel has a
Question about PL4260N 42 in. Plasma HDTV
Sony Plasma KE-42M1 -70 volt section is not stable when Y sustain board is When the Y sustain board is connected to the -70 volt supply the -70 swings to all kinds of voltages. But when the Y sustain ...
Question about HPT5054 50-Inch Plasma HDTV
...sustain board.The Y buffer boards looked good. Now when I reassembled the unit,st Replaced the main y sustain board Did it work with the Y-sustain board replaced? Likely if it did not work then there ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions