Questions & Answers for: Suzuki swing arm

Ad

Question about 2005 RM-Z 250

1 Answer

...swing arm parallel to the ground, (this is the tightest point in the arc of the swing arm moving rotation), at that point you want to be able to put two finger between the chain and the swing arm at ...

Ad

Question about 2000 TL 1000 R

1 Answer

...swing-arm: this will lock wheel from rotating while you crack the nut.  NEVER put the transmission in gear.  When re-torquing the nut after refitting, put the 2 x 4 under the swing-arm ...

Ad

...swing arm, etc. on a GSF 1200 I need to replace the rear tire on my '98 Bandit GSF 1200S. A local shop told me "everybody" is running the 190/50 17 on their Bandits. It appears that clearance for the ...

Question about 1981 Gs 550 L

1 Answer

...swing arm, then loosen the lock bolt on the top of the chrome adjuster ( left and right adjusters ), then loosen the lock nut on the long adjuster screw. Run the nut about 1/2" down the length of the ...

Question about 1998 VZ 800 Marauder

2 Answers

...swing arm you tighten them to take the slack out of the chain. NOT TO TIGHT! You should have 1 inch of play in the chain this is up down play not front to back. I push the chain up the highest it can ...

...swing arm bushings or bearings, swing arm bearing preload, worn defective shock, bent frame, rims. forks. misaligned forks. fork stiction. Prevention is in making all above are correct., a steering ...

...swing arm of my TL1000R? If there is no grease fitting in the swing arm housing then it's a sealed bearing,can't grease it.If it goes out replace it.Check manual to see if there is replacement ...

Question about 2004 DR 200 SE

1 Answer

...swing arm at the back is their two bolts sticking out the end of each swing arm their should be one in one side of the swing arm and one in the other side of the swing arm, this is right at the very ...

Question about 2001 DR-Z 250

1 Answer

...swing arm that tells me the recommended pressure. If the sticker is not on the swing arm try looking on the frame around the side covers. You should be able to run 32 psi to 35 psi front and rear for ...

Question about 2006 Boulevard C90

1 Answer

2006 c90 swing arm bearing replacement torqe specification for swing arm bearing how do you remove the swing arm from susuki c90

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6151 Answers

ROB

Level 3 Expert

858 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...