Questions & Answers for: Harley Davidson swing arm Motorcycles

Question about 2005 FXDWG - FXDWGI Dyna Wide Glide

1 Answer

...rear 150 section. might get a 180 section with standard rear swing arm or 240 with modified swing arm shock mounts and extended drive sprocket and cover. do a search on wide tyre(tire) kit for

Ad

Question about 2001 FXSTB Night Train

1 Answer

...swing arm removed belt put behind swing n arm and the wheel losened and slide the wheel forward dont force the belt and after 100miles check the belt tension if so adjust it and also you will require ...

Ad

Question about 2000 FLHTCUI Electra Glide Ultra Classic

1 Answer

...Not sure what you are asking? The wheel alignment should align when you adjust your belt deflection by the axle cam.Unless you have changed the swing arm or any bearings or bushing in the swing

Question about 2000 FLHTCUI Electra Glide Ultra Classic

1 Answer

...swing arm bearings on 1970 sportster Get the bike up off the ground and make sure it's secure. Remove the rear wheel and the rear shocks. Look for anything else that may be attached to the swing arm ...

Question about 2000 FLHRCI Road King Classic

1 Answer

...a lowering kit on a 2003 roadking classic affect the belt No, it is not going to affect the swing arm but will only lower the chassis with respedct to the swing arm height whoich will remain the

Question about 2000 FLHRCI Road King Classic

1 Answer

...swing arm off of a 1982 harley davidson Raise rear tire off ground. Loosen chain adjusters, loosen and remove axle nut and remove axle. Remove chain from rear sprocket. Remove bolt from lower shock ...

Question about 2006 FXDBI Street Bob

1 Answer

...swing arm into a short spacer, through right wheel bearing, internal spacer, left wheel bearing out the left side through a longer spacer, and then the swing arm and then on the axle you will have a ...

Question about 1993 FXR Super Glide

1 Answer

...swing arm has to come off to allow the belt to go around it. Disconnect shocks from swing arm (lower mounts only will be ok) Remove swing arm. Install new belt on drive pulley, replace swing arm ...

Question about 2009 FXDC Dyna Super Glide Custom

1 Answer

should there be & could I make a bushing out of molebdenum? Lay the bike on its side. Superglue the bush to the swing arm. Lay the bike over the other way and repeat. Do not glue the bush to the shaft

...swing arm 2005 fxd Super glide diagram please? Question edited for a lot more clarity. Question moved to model category. Diagrams and the Service Manual in the link Stacy. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...