Question about DES-1008D 8-Port Ethernet Switch (790069217708)
...cable - switch 2 - 2 machines ?If so, the problem is with the 400ft cable. Ethernet specifications allow for only 100 meters (~325ft) of cable for reliable connectivity. You can push it a little bit, ...
Question about 2-wire Pull Chain Light Switch For Ceiling Fan Lights
cable from switch to pull switch then to i want to run a live cable from wall switch to bathroom pull switch and then connect the wall light cable to pull switch How do i connect these cables. If I am
Question about DES 1005D (DES-1005D) 5x10/100 Mbps Networking Switch
...cable from pc to switch longer and ADSL modem to switch longer and cable between switches shorter. Use a known good straight through ethernet cable, as modern switches don't require crossover cables. ...
Question about ACE6001V-K "ACE" ROTARY DIAL DIMMER
cable). Your switch box sends one cable to the Load (light, fan etc), but it also sends another cable to the next box which has a receptacle or another switch. If your box has a third cable that feeds
...switch. (B) Cable B: One cable goes to garage lights. Black wire going to garage lights connects to on-off switch. So the garage light switch has 2 black wires: 1 black wire from cable A, and 1 black ...
...cable from the switch location to the fan/light box.At box #1 (a 2 gang box), you will run a power cable (marked cable #1) into it. From there you run 2 sets of 3-wire cables (identified as ...
Question about 2002 FXDL Dyna Low Rider
cable first. 3. Unscrew ignition/light lock ring. Push switch back through hole. 4. Cut switch wires approximately 3.0 in. (76 mm) from switch body. The new switch must be spliced into existing wiring
Question about 2002 FXDL Dyna Low Rider
...switch has 3 cables: neutral, hot, load. And, the cable to the light has only 2: white and black. What do I connect these 3 cables to 2 cables? Copy following link for motion sensor and occupancy ...
cable first. 3. Unscrew ignition/light lock ring. Push switch back through hole. 4. Cut switch wires approximately 3.0 in. (76 mm) from switch body. The new switch must be spliced into existing wiring
...cable used to connect the said switch to PC. (b) How to manage or configure the switch using the needed console cable to open the RJ45 ports to make it a normal switch. REASON: Because when I connect ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions