...and date every time thhs happens.. ?????? The first thing I would check would be the magnetron TCO (thermal cut-out). This is a little safety devise that protects the magnetron in the event of ...
...it) thinking she was using the timer until it overheated and shut off. No power at all. I replaced TCO's that were open. Everything works fine now, all functions work properly except the Vent fan ...
MICROWAVE SUDDENLY TURN OFF. I CHECKED ALL OUT LET. I THING THE FUSE IS BLOWN OFF. DO YOU KNOW WHERE IS THE FUSE BOX LOCATED OF MAYTAG MMV 5207 BAB I would suspect the magnetron T.C.O., or possibly ...
...it be? after removing the cover of microwave chk for continuty of cavity thermostat usually calld TCO(thermal cut off). it is located on top of the cavity and circular in shape.usually neutral wire ...
...now doesn't work. Fuses seem OK. most likely the thermal fuse ( usually calld thermal cut off orTCO) which is mounted on top of the cavity and is to protect the cavity from over heating has blown ...
...vent blower start running and wont turn off. I would say you replaced a good hood thermostat (or "TCO" / thermal cutout) with a new thermostat of the wrong type. The oven cavity TCO and the ...
Wiring to MGT T.C.O MGT T.C.O wiring. can the W1 and W2 be on either side, same with the BL1 and W6. You went this far.. check the wiring diagram they are free to download
Question about Microwave Thermal Cutout Wb27x10194
GE microvave TCO WB27X10194 is open when tested with a VOM. All functions work except the the microwave will not heat. I presume the TCO is defective and needs replacement. checked the TCO with VOM ...
Question about Microwave Thermal Cutout Wb27x10194
...controller. You should check the continuity of the fuse (on the noise filter board), the "bottom TCO," the "MGT TCO" on or near the magnetron, and the "cavity TCO." The first two can usually be ...
Question about Microwave Thermal Cutout Wb27x10194
...controller. You should check the continuity of the fuse (on the noise filter board), the "bottom TCO," the "MGT TCO" on or near the magnetron, and the "cavity TCO." The first two can usually be ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions