...i had to replace the altenator and now i just dont know how to do it without destroying the belt. think you could help? relax belt tension regulator, install belt. then tighten tension
thread bunches up under fabric Your thread tension needs adjustment. Most likely it is the lower thread tension (not the upper thread tensioner). When sewing very thin or very heavy material - it is ...
...revs is it the voltage regulator problem and is it located in the alternator check the belt and tensioner , a worn belt tensioner can cause such problems. unfortunately the tensioner is the ...
...tension regulator button has fallen out and I was given an old machine and the thread tension regulator button has fallen out and dont know how all the parts of it go back and in what order Really do ...
...tension. The regulator lift arm isunder tension from the counterbalance spring and can cause personalinjury if the motor is removed from the regulator. Remove the window regulator. Drill a hole ...
Question about 2002 Blazer
...of the tension regulator wont tighten on my kenmore 19461 model How do I fix the tension regulator so the disks will tighten? Check that the tension release lever on the presser foot is not
Question about 2002 Blazer
...case and thread through slot and under the spring. Spring has small screw which regulates the tension. Hold the lot by thread like yo-yo and jerk a little down-up. It should drop just a little ...
Question about 2002 Blazer
i have a athena 2000 electronic and the tension dial does not move the feeding dogs so to be able to adjust the tension how can I fix it The tension has nothing to do with the feed dogs. All the feed ...
Question about 2002 Blazer
...Tension Regulator for my White Sewing Machine Model 7013 Serial No. 6271 eBay. In the search engine type in "machine parts and attachments.", and then "Tension Regulator for my White Sewing Machine ...
Question about 250 Recumbent Bike
tension regulator please? The tension regulator is not working. There are two possibilities. 1. Tension regulator is broken. 2. Circuit board controlling the tension regulator is not working. Question
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions