...thermal cutout (thermal fuse) on the magnetron opened up. It may or may not also indicate a bad magnetron. If you or a friend decide to work on it, we have *critical* safety, disassembly, and ...
...thermal cutout on or near the magnetron inside. If you or a friend decide to look into it, we have critical safety information and disassembly information at our site, linked here on Fixya: ...
...thermal cutout or thermostat (whichever it uses) is open. It is located on or above the magnetron. When the mag gets too hot, this device protects it from destructive overheating by cutting power to ...
...thermal cutout on the magnetron. All these will interrupt power if open. The best place to order Sharp parts is Tritronics. Please write back if you need further help. We're happy to help you with ...
...thermal cutout. I don't have an exploded view on this one, and the supplier's part list is not detailed properly, so you would have to remove the magnetron thermal cutout and look for the numbers on ...
Question about R-930AK Convection/Microwave Oven
thermal cutout on top of the cavity. You can order parts from Encompass here or call them toll-free at 866-779-5835. We're happy to help you with free advice and we'd appreciate your thoughtful rating
...thermal cutout is probably not bad. It should read normally open, unlike the others, which would read normally closed. What probably blew the fuse was a blown high voltage rectifier diode. At our Web ...
...thermal cutout. We have the service manual and have uploaded it to our site here to help you. The fuse should be accessible just behind the grill. At our Web site, we have a video available showing ...
...thermal cutout (see the Applaince Controls Fix-It Guide), and the fan, replacing parts that don't pass the test. If the oven keeps blowing fuses, check for a faulty door interlock or monitor ...
Question about R820JS 900 Watts Convection Microwave Oven
...low of a temperature. Or, the magnetron might be running too hot causing it's thermal cutout to open. If equipped with a thermistor on the magnetron instead of a cutout, it may have drifted in
Usually answered in minutes!
275 Questions
129 Questions
117 Questions
86 Questions
95 Questions