Questions & Answers for: thermal cutout Heating & Cooling

Question about Washing Machines

1 Answer

thermal cutout. jumpered it and got heat. the jumper wire (smaller gauge) immediately got warm Where might my real problem be. ohms on heater element were 8 The problem is with the Thermal Cutout. The

Ad

Question about Ovens

1 Answer

power to oven lights but not to cook top or oven. checked pigtail and breaker, both ok. Thermal cutout? Yeah sounds like a Thermal cutout to me ... do you have 120V on both sides??

Ad

thermal cutout required-no heater element working but heater element is fine when cutout is temporarily bridged-need part nr of cutout Usually, there are 2 or 3 thremal cutouts in these machines (Side

thermal cutout, What causes this? Condenser fan motor but compressor will not start. Relay does not engage. if it's a thermal cutout that's mounted on the circuit board you may have to replace

...thermal cutout pops on tank two after it shuts off. It boils then shuts off. It also turns off when taking a shower, producing cold water. I checked the ohm readings on the thermal cutout and the ...

Question about 2003 FLHTCUI Electra Glide Ultra Classic

1 Answer

...shuts down when hot? After it cools down for a few minutes it starts back up. Thermal safety cutout is shutting down ignition, if you don't feel the engine is that hot replace thermal cutout and ...

Question about 2003 FLHTCUI Electra Glide Ultra Classic

1 Answer

Thermal overload cutout tripped or is defective and needs replaced. Look for a red reset button near the heater element on the thermal overload. If no reset button, replace the thermal overload cutout

Question about 2003 FLHTCUI Electra Glide Ultra Classic

1 Answer

thermal cutout (thermal fuse) must be replaced. However, when any "fuse" is bad, it indicates a problem with the normal operation of the machine and the fuse has protected the machine by disconnecting

Question about 2003 FLHTCUI Electra Glide Ultra Classic

1 Answer

...thermal cutout switch tripped (for no apparent reason) and lost second stage of heating. reset thermal cutout switch - water is now hot - but the light is not on when hot water is flowing. cutout did ...

thermal cutout. A thermal cutout is a safety feature that is designed to shut down the motor when it becomes too hot, in order to prevent damage or overheating. When the motor cools down sufficiently,

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...