...thermostat is bad, the fan will work properly during heating. I know July is a bad time to turn the heat on, but this is a method to see if the interior fan works properly and is not getting the ...
...bad. you can check the thermostat and the defrost heater with an ohm meter on tone. they are both located behind the back panel in the freezer. ( Note: do not thaw freezer until thermostat has been ...
Question about ARB8057CSL Bottom Freezer Refrigerator
...the Freezer and refrig both too cold. Adjusting the dials doesn't help. If turning the freezer cold control (thermostat) all the way doesn't turn the compressor off then the thermostat is
Question about ARB8057CSL Bottom Freezer Refrigerator
...the batteries. If you have the brand and model # of the thermostat, you can do a Google search for the owner's manual. Of course there is always the possibility that the thermostat has gone
...bad heater or defrost thermostat. To check heater and thermostat I would go to parts site on Internet and type in model no. And see if they have diagnosis videos on this or similar ref. Otherwise buy ...
Question about ASD2622HRQ Side by Side Refrigerator
...Your defrost heater or defrost thermostat may be bad. Test defrost heating element for continuity. If heater is good, replace the defrost thermostat. In most cases, replacing both is
Question about ASD2622HRQ Side by Side Refrigerator
...thermostat thats go bad or your fan motor..the defrost thermostat is located behind cover in freezer...one side is connected to your heater and the other is the line wire....you can actually bypass ...
...off, what can I check? Hello, take the thermostat off the wall and disconnect the wires, if this turns blower off you have a bad thermostat, if it does not turn it off you have a bad control
Question about ARB9058C Bottom Freezer Refrigerator
...bad,try this,it's a good idea to change out the thermostat to while you're in there so do this,shut down the freezer control or unplug the machine,cut the two wires going to the thermostat ...
...failure, replace board,5blinks/sec--pot. failure,replace board;6blinks/sec--bad thermostat input; 7blinks/sec--factory only;8blinks/sec--bad room thermostat. The blink pattern repeats every 5
Usually answered in minutes!
201 Questions
59 Questions
39 Questions
36 Questions
31 Questions