Bobbin has no motion I ran out of bobbin thread. I reloaded the bobbin. I replaced the bobbin in the exact same spot it always goes, threaded the thread according to the diagram as always, and now the
Question about Jem Silver 662 Mechanical Sewing Machine
I cant remember how to fill the bobbin with thread :( Insert the empty bobbin case onto the bobbin winder in the sewing machine. Step 2 Set the spool of thread onto the thread peg. Use the same thread
Question about Jem Silver 662 Mechanical Sewing Machine
hi, using a jonome finesse model 356, changed the thread on the bobbin and now its knotting up and not loose from the bottom, did i thread it incorrectly? tension is wrong now?? thanks! Check that the
Question about D'cor Excel Pro 5124 Mechanical Sewing Machine
threading 3.Bobbin wound to tight or uneven=====try new bobbin 4.lint or thread on bobbin case=======clean inside case 5.Lint or thread inside hook==========clean inside hook 6.Bobbin case nicked bent
thread breaking when the thread grabs the bobbin thread to pull it up it gets stuck... once it starts sewing the thread breaks and jars the bobbin holder The needle thread breaks 1. the needle thread ...
Question about D'cor Excel Pro 5124 Mechanical Sewing Machine
bobbin thread is jammin up after about 3 rotations of wheel on my janome 8077 - is this a timing problem? cleaned the lint out of area and rethreaded bobbin several times - needle picks up bobbin ...
Question about Memory Craft 3000
janome 3000 bobbin thread will not catch. It just quit while I was sewing. I've cleaned the bobbin case and anything else I could but when I put the needle down the thread does not circle the b ...
Question about Magnolia 7330 Sewing Machine
after 2 or 3 stitches needle gets locked with balled thread needle thread and bobbin thread gets balled and needle can't move Lint and or thread has collected behind or under the bobbin. use a q-tip ...
bobbin thread shows on embroidery pattern The white bobbin thread keeps showing in the embroidered side.sometimes the top color thread doesn't show at all The bobbin thread is being pulled too hard by
Question about Memory Craft 10000
I have a janome memory craft 350E, when I embroider it is pulling the bobbin thread through to the right side, I have changed the tension but it is still doing it. Can you help please I suspect the ...
Usually answered in minutes!
565 Questions
193 Questions
102 Questions
90 Questions
79 Questions