Question about Fashionaire Sewing 2380 Mechanical Sewing Machine
threading on my needle and the bobbin thread. Closer examination showed the upper and lower threads are not locking together. I cannot get the bobbin thread to loop into the needle thread so I can sew
want pick up my bobbin it was doing fine and then all the top thread wound up on my bobbin then got all that clean out and now it want pick up my bobbin thread keeps giving me a error that the thread ...
My bobbin thread will not thread. When I bring the needle down, it comes up without the bobbin thread. The mechanism moves, but no thread. How do I fix this problem? check the bobbin to make sure it's
The bobbin thread will not pick up. The machine had jammed and I forced the wheel and can't get bobbin thread to pick up. When I thread manually, I only get holes, no stitches. Is it a timing belt? ...
threading 3.Bobbin wound to tight or uneven=====try new bobbin 4.lint or thread on bobbin case=======clean inside case 5.Lint or thread inside hook==========clean inside hook 6.Bobbin case nicked bent
I bought my daughter a White sew E-Z so she can have fun on her first sewing machine. However there is no manual and no instructions on how to thread the bobin. the bobin just sits on its flat side to
Question about 1409 Mechanical Sewing Machine
bobbin,threading from the inside of the bobbin to the out side .hold the thread on the outside of the bobbin and wrap thread around the bobbin shank twice. Hold the thread in place and find the groove
Question about 915
Bernina 1080 Solution for "back spin"? Top thread suddenly becomes very loose. Top thread forms loops under cloth being sewn. Try these suggestions 1. Change the needle--use a needle that's for the ...
...bobbin. 3. After threading the top place the thread under the pressure foot and hold on to the thread. Turn the hand wheel towards you. 4. The needle has went under the throat plate (feed dogs plate) ...
Question about 2999 Mechanical Sewing Machine
...a brand new needle. Remove the thread from the machine. ALWAYS RAISE the presser foot while rethreading the upper thread. Confirm the thread path is correct. Verify the bobbin is installed ...
Usually answered in minutes!
125 Questions
116 Questions
88 Questions
79 Questions
49 Questions