...cylinder was running hot, rear cylinder running cool, bike stalled out, now won't start. Spark plugs won't fire. could be a problem in you sparkplug boot, carbourator, or a stretched throttle
...throttle cable where it connects to the throttle. This is critical for carburetor synchronization. Remove the choke cables. Front choke cable is held in place by a phillips head screw remove it the ...
throttle cable is not broke may be your throttle assembly has moved round a bit and has snagged the throttle cable you sometimes also have a throttle cable adjuster somewhere along the cable the outer
idle speed adjuster. When the engine revs just by turning the handlebars this is the routing of the throttle cables hanging up, and pulling on the cables when you turn the bars....reroute cables
Question about 1994 VS 1400 Intruder
...getting a delay almost a winding up?? Throttle cable? Carberator jets? transmission / shaft drive? possibly clutch slip , does it rev up higher but theres a delay in the bike speed matching the revs
Question about 1994 VS 1400 Intruder
When I start my 1400 suzuki intruder it is stuck at full throttle even though the cables are loose and the throttle arms are in the neutral position. Any ideas what the problem may be The carby ...
Question about 1996 VS 1400 Intruder
...cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 5. Throttle controls not adjusted correctly. 6. Water or dirt in the fuel system. 7. Water or dirt in the ...
Question about 1996 VS 1400 Intruder
the throttle cable travel then compares the two signals calculates the preset number that is sent to computer module. The switch is anchored by two screws the adjustment there determine correct signal
Question about 1999 VS 1400 Intruder
...Good luck and have a nice day. Suzuki Intruder Throttle Choke Cables eBay Replacing your Choke cable on GSX600 Suzuki Intruder VS1400 Service Manual OEM parts for Suzuki Suzuki VS1400 Owner ...
Question about 1995 VS 1400 Intruder
...cable harness at "BOTH" ends. 4. Faulty main circuit breaker or ignition switch, check for loose connections and continuity. 5. Faulty system and or ignition relay, check for continuity. 6. Faulty ...
Usually answered in minutes!
102 Questions
52 Questions
34 Questions
34 Questions
29 Questions