...thumb is to put a light coat of oil on the filter gasket, screw it in till the gasket touches and then turn it another 3/4 turn. i dont think there is an actual torque spec for an oil filter, oil ...
...trunk, or under bumper? open the trubnk and pull carpet away from lens assembly,remove five plastic thumb screws to remove turn signal assembly,and pull out on assembly just turn the bulb counter ...
thumb screw on the left side of the headlight assembly as well as the thumb screw on the top of the head light assembly. The third thumb screw simply anchors the turn-signal assembly to the head light
I want to replace the radio and do not know what I need to replace the radio and do not know what to remove to access the radio.Any special tools? Simply pull off the pull off the plastic bezel (quick
How do I replace the taillight bulb on a 2001 Chevy cavalier? In the trunk - find the plastic thumb screws and un-do them You might have to look behind the carpeted cover. The tail light will come off
car wont start. where is the battery located The battery is located under the cover immediately behind the Head lamp assembly remove the three screws that secure the cover and push the 4 tabs on the ...
...you need to go into the trunk remove the carpet from the tail light area there should be some thumb screws you need to undo them then slide out the tail light. or some models you can access the ...
...P.S. If this does help, please leave feedback. If it has a carburetor the answer is yes. Basic thumb rule is turn both fuel & air adjustment screws (brass screws with holding springs) all
...but dont quote me here as never done one ,some vehicles have screws on the outside then a plastic thumb nut behind the carpet ...
...thumb over the end of a long flat blade screw driver, place it carefully on each injector, and place your thumb on your ear. With the engine running, listen for fires from the injector -----> are ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions