Question about Professional Door Lock installation Kit
...thumb turn,the 2 long screw is missing from the front,so the lock jiggles a lot redmaid there should be a small allen screw on the shaft of the thumb turn on the inside. loosen the allen screw, pull ...
Question about Professional Door Lock installation Kit
cannot match up the screw holes. everytime we think we have it the screws just spin HELP! What I do in this situation is put my tongue out the left side of my mouth about 1/2 inch. My friend, you must
Question about 4 Lido Lh Passage Levers Satin Chrome 200ll 26d
We have the thumb press elongated handle on the outside of the front door entry. I was ready to enter the front door when I pressed the thumb handle and the whole set fell apart. Need instructions to ...
Question about 4 Lido Lh Passage Levers Satin Chrome 200ll 26d
kwikset thumb plate on handleset is loose and won't work Remove outer trim, tighten inner trim, put outer trim back. Go to Kwikset.com for full installation instructions for your model.
Question about 4 Lido Lh Passage Levers Satin Chrome 200ll 26d
How do I tighten a deadbolt lock with no visible screw? It has key on both sides. Inside plate has 2 holes in it that I thought would rotate to expose screws. It does not. How do I proceed? How do I ...
Question about 4 Lido Lh Passage Levers Satin Chrome 200ll 26d
...the latch mechanism of a kwikset 510 handle set? the latch assembly does not work with the outside thumb release on my kwikset 510 handleset. How do I adjust it? ...
Question about 4 Lido Lh Passage Levers Satin Chrome 200ll 26d
How to repair a pre- 1960 thumb press front doorlock? Most locksmiths can repair these and some universal parts are available. It may end up costing more than a new lock though. Some problems are easy
Question about 4 Lido Lh Passage Levers Satin Chrome 200ll 26d
... Use a paperclip or an awl with a fine point to press the pin-hole to release the lever. Remove the thumb-turn lever. I have used several items to push in the pin-hole, including a 1/16 allen wrench, ...
Question about Dakota Handleset
- i have a kwikset polished brass dakota handleset on my front door. somehow the pin that holds the thumb pedal in place has gotten lost, so the thumb pedal falls out. am i likely to find one of these
Question about Dakota Handleset
How to remove the latch of a deadbolt with no latch screws? The deadbolt that I am trying to remove has a latch with no screws, just two holes at top and bottom. I tried to use an allen inside those ...
Usually answered in minutes!
129 Questions
93 Questions
60 Questions
24 Questions