Questions & Answers for: Pontiac Montana SV6 thumb screw

real right turn signal light - Pontiac Montana SV6 2005 Hello, How do I replace the bulb for the rear right turn signal light on my 2005 Pontiac Montana SV6. I bought the replacement bulb at the store

i bought front rotors 4 a pontiac sv6 montana and the orig ones have a torx screw in the rotor the new ones do not.did i buy the wrong rotors? no this wae just factory,,,they are not crucial,the ...

pontiac brake rotors sv6 2005 NEW i bought new frnt rotors 4 my pontiac sv6 montana and the old ones have a torx screw in them and the new ones donot.did i buy the wrong rotors?the new rotors do not ...

did ibuy the wrong rotors?old ones have set screw new ones do not even have a hole for the set screw. is this alright? yes it will be ok!!! :) The lugs will provide enough. they are from factory and ...

How do I replace the rear wiper motor in my 2005 Montana SV6? The motor just stopped today. You need to remove the large plastic panel off the back interior of the hatch. 2 screws where the handle is ...

...thumb screw on the upper inboard corner of the turn signal assembly Remove the screw with the screwdriver.Pull the turn signal assembly outward away from the fender and then disconnect the ...

how to remove the headlamp I did follow instruction in the ower manual but some reason I COULD PUT OUT I remoe the screw b from headlamp also retainer pin Firmly pull the headlamp forward (towards you

how do I remove the front console cupholder tray on my 2006 pontiac sv6 van? Something fell behind it and I need to retrieve it. There should be 4 access screws holding it down locate them in the ...

How to replace throttle position sensor the throttle position sensor is located on the throttle body directly across from where the throttle cable are attached. Remove the two screws holding it in ...

my tailgate locked while it was opened, now it wont close. How do I get it unlocked so I can close it. If you have a key fob, double click unlock then open latch. You may have to use a screw driver to